관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
분야 | 05.01 : 석유제품 및 윤활유 (Ⅰ) |
---|---|
적용범위 | 1.1 This test method covers the determination of the amount of carbon residue (Note 1) left after evaporation and pyrolysis of an oil, and it is intended to provide some indication of relative coke-forming propensity. This test method is generally applicable to relatively nonvolatile petroleum products which partially decompose on distillation at atmospheric pressure. This test method also covers the determination of carbon residue on 10 % (V/V) distillation residues (see Section 10). Petroleum products containing ash-forming constituents as determined by Test Method D482, will have an erroneously high carbon residue, depending upon the amount of ash formed (Notes 2 and 3). Note 1: The term carbon residue is used throughout this test method to designate the carbonaceous residue formed during evaporation and pyrolysis of a petroleum product. The residue is not composed entirely of carbon, but is a coke which can be further changed by pyrolysis. The term carbon residue is continued in this test method only in deference to its wide common usage. Note 2: Values obtained by this test method are not numerically the same as those obtained by Test Method D189, or Test Method D4530. Approximate correlations have been derived (see Fig. X2.1) but need not apply to all materials which can be tested because the carbon residue test is applicable to a wide variety of petroleum products. The Ramsbottom Carbon Residue test method is limited to those samples that are mobile below 90 °C. Note 3: In diesel fuel, the presence of alkyl nitrates such as amyl nitrate, hexyl nitrate, or octyl nitrate, causes a higher carbon residue value than observed in untreated fuel, which can lead to erroneous conclusions as to the coke-forming propensity of the fuel. The presence of alkyl nitrate in the fuel can be detected by Test Method D4046. Note 4: The test procedure in Section 10 is being modified to allow the use of a 100 mL volume automated distillation apparatus. No precision data is available for the procedure at this time, but a round robin is being planned to develop precision data. The 250 mL volume bulb distillation method described in Section 10 for determining carbon residue on a 10 % distillation residue is considered the referee test. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 WARNING—Mercury has been designated by many regulatory agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA’s website—http://www.epa.gov/mercury/faq.htm—for additional information. Users should be aware that selling mercury and/or mercury containing products into your state or country may be prohibited by law. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
국제분류(ICS)코드 | 75.080 : 석유제품 일반 |
페이지수 | 9 |
Edition | 15 |
No. | 표준번호 | 표준명 | 발행일 | 상태 |
---|---|---|---|---|
1 | ASTM D524-15(2019) | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2019-12-01 | 표준 |
2 | ASTM D524-15 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2015-06-01 | 구판 |
3 | ASTM D524-15 REDLINE | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2015-06-01 | 구판 |
4 | ASTM D524-10 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2010-07-01 | 구판 |
5 | ASTM D524-09 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2009-06-01 | 구판 |
6 | ASTM D524-04 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2004-11-01 | 구판 |
7 | ASTM D524-03 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2003-09-10 | 구판 |
8 | ASTM D524-00 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2000-04-10 | 구판 |
9 | ASTM D524-00e1 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 2000-04-10 | 구판 |
10 | ASTM D524-88 | Standard Test Method for Ramsbottom Carbon Residue of Petroleum Products | 구판 |
관련상품이 존재하지 않습니다.
ASTM D4878-15 - Standard Test Methods for Polyurethane Raw Materials: Determination of Viscosity of Polyols 상세보기
ASTM D4530-15 - Standard Test Method for Determination of Carbon Residue (Micro Method) 상세보기
ASTM D156-15 - Standard Test Method for Saybolt Color of Petroleum Products (Saybolt Chromometer Method) 상세보기
ASTM D189-06(2014) - Standard Test Method for Conradson Carbon Residue of Petroleum Products 상세보기
ASTM D1209-05(2011) - Standard Test Method for Color of Clear Liquids (Platinum-Cobalt Scale) 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기