관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Fans (PTC 11 - 2008)
| 분야 | PTC : Performance Test Code |
|---|---|
| 적용범위 | This Code provides standard procedures for conducting and reporting tests on fans, including those of the centrifugal, axial and mixed flow types. This Code provides the rules for testing fans to determine performance under actual operating conditions. It also provides additional rules for converting measured performance to that which would prevail under specified operating conditions. Some of the quantities that can be determined include fan mass flow rate, fan specific energy and fan input power. The scope of this Code is limited to the testing of fans after they have been installed in the systems for which they were intended. However, the same directions can be followed in a laboratory test. (The laboratory test performance may not be duplicated by a test after installation because of system effects.) The term fan implies that the machine is used primarily for moving air or gas rather than compression. The distinction between fans, blowers, exhausters, and compressors in common practice is rather vague; accordingly, machines that bear any of these names may be tested under the provisions of this Code. |
| 국제분류(ICS)코드 | |
| 페이지수 | 176 |
| Edition |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASME PTC 11-2008(R2018) | Fans (PTC 11 - 2008) | 2008-01-01 | 표준 |
관련상품이 존재하지 않습니다.
ASME PTC 10-1997(R2014) - Performance Test Code on Compressors and Exhausters (PTC 10 - 1997) 상세보기
ASME PTC 8.2-1990 - Centrifugal Pumps (PTC 8.2 - 1990) 상세보기
ASME PTC 1-2015 - General Instructions (PTC 1 - 2015) 상세보기
ASME PTC 19.3 TW-2016 - Thermowells 상세보기
ASME PTC 24-1976(R1982) - Ejectors (PTC 24 - 1976) 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
