관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water
| 분야 | 11.01 : 물 (Ⅰ) |
|---|---|
| 적용범위 | 1.1 This practice covers the procedure used to perform pressure in-line coagulation-flocculation-filtration of water and waste water. It is applicable to water and waste water with relatively low suspended solids (<30 mg/L). The practice is applicable for any size filter greater than 100 mm (4 in.) in diameter. 1.2 This practice for performing pressure in-line coagulation-flocculation-filtration tests in water relies on turbidity measurement to assess the water quality, referring to Test Methods D7315, D6698, or D6855 to perform the turbidity measurement. 1.3 This practice can be used to determine the effectiveness of flocculants or coagulants, or both, and filter medium(a) in removing suspended and colloidal material from water and waste water. 1.4 Interval between filter backwashing, backwash requirements, rinse requirements, and effect of filtration rate on effluent quality can also be obtained with this practice. 1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| 국제분류(ICS)코드 | |
| 페이지수 | 4 |
| Edition | 17 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASTM D4188-17 REDLINE | Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water | 2017-12-15 | 표준 |
| 2 | ASTM D4188-17 | Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water | 2017-12-15 | 표준 |
| 3 | ASTM D4188-13 | Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test in Water | 2013-01-01 | 구판 |
| 4 | ASTM D4188-08 | Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test | 2008-07-01 | 구판 |
| 5 | ASTM D4188-82(1999) | Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test | 1999-06-10 | 구판 |
| 6 | ASTM D4188-82(2003) | Standard Practice for Performing Pressure In-Line Coagulation-Flocculation-Filtration Test | 1982-10-29 | 구판 |
관련상품이 존재하지 않습니다.
ASTM F1524-95(2013) - Standard Guide for Use of Advanced Oxidation Process for the Mitigation of Chemical Spills 상세보기
ASTM D4195-08(2014) - Standard Guide for Water Analysis for Reverse Osmosis and Nanofiltration Application (Withdrawn 2023) 상세보기
ISO 16784-2:2006 - Corrosion of metals and alloys — Corrosion and fouling in industrial cooling water systems — Part 2: Evaluation of the performance of cooling water treatment programmes using a pilot-scale test rig 상세보기
ISO 21630:2007 - Pumps — Testing — Submersible mixers for wastewater and similar applications 상세보기
ISO 24516-4:2019 - Guidelines for the management of assets of water supply and wastewater systems — Part 4: Wastewater treatment plants, sludge treatment facilities, pumping stations, retention and detention facilities 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
