관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
분야 | |
---|---|
적용범위 | 1.1 This test method describes a procedure for the determination of the weight percent volatile content of solventborne and waterborne coatings. Test specimens are heated at 110 ± 5°C for 60 min. Note 1: The coatings used in these round-robin studies represented air-dried, air-dried oxidizing, heat-cured baking systems, and also included multicomponent paint systems. 1.2 Sixty minutes at 110 ± 5°C is a general purpose test method based on the precision obtained with both solventborne and waterborne coatings (see Section 9). 1.3 This test method is viable for coatings wherein one or more parts may, at ambient conditions, contain liquid coreactants that are volatile until a chemical reaction has occurred with another component of the multi-package system. Note 2: Committee D01 has run round-robin studies on volatiles of multicomponent paint systems. The only change in procedure is to premix the weighed components in the correct proportions and allow the specimens to stand at room temperature for 1 h prior to placing them into the oven. 1.4 Test Method D5095 for Determination of the Nonvolatile Content in Silanes, Siloxanes and Silane-Siloxane Blends Used in Masonry Water Repellent Treatments is the standard method for nonvolatile content of these types of materials. 1.5 Test Methods D5403 for Volatile Content of Radiation Curable Materials is the standard method for determining nonvolatile content of radiation curable coatings, inks and adhesives. 1.6 Test Method D6419 for Volatile Content of Sheet-Fed and Coldset Web Offset Printing Inks is the method of choice for these types of printing inks. 1.7 This test method may not be applicable to all types of coatings. Other procedures may be substituted with mutual agreement between the producer and the user. Note 3: If unusual decomposition or degradation of the specimen occurs during heating, the actual time and temperature used to cure the coating in practice may be substituted for the time and temperature specified in this test method, subject to mutual agreement between the producer and the user. The U.S. EPA Reference Method 24 specifies 110 ± 5°C for 1 h for coatings. Note 4: Practice D3960 for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings describes procedures and calculations and provides guidance on selecting test methods to determine VOC content of solventborne and waterborne coatings. 1.8 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
국제분류(ICS)코드 | |
페이지수 | 6 |
Edition | 20 |
No. | 표준번호 | 표준명 | 발행일 | 상태 |
---|---|---|---|---|
1 | ASTM D2369-24 | Standard Test Method for Volatile Content of Coatings | 2024-02-01 | 표준 |
2 | ASTM D2369-24 REDLINE | Standard Test Method for Volatile Content of Coatings | 2024-02-01 | 표준 |
3 | ASTM D2369-20 REDLINE | Standard Test Method for Volatile Content of Coatings | 2020-06-01 | 구판 |
4 | ASTM D2369-20 | Standard Test Method for Volatile Content of Coatings | 2020-06-01 | 구판 |
5 | ASTM D2369-10(2015)e1 | Standard Test Method for Volatile Content of Coatings | 2015-06-01 | 구판 |
6 | ASTM D2369-10e1 | Standard Test Method for Volatile Content of Coatings | 2011-07-01 | 구판 |
7 | ASTM D2369-10 | Standard Test Method for Volatile Content of Coatings | 2010-07-01 | 구판 |
8 | ASTM D2369-07 | Standard Test Method for Volatile Content of Coatings | 2007-07-01 | 구판 |
9 | ASTM D2369-04 | Standard Test Method for Volatile Content of Coatings | 2004-03-01 | 구판 |
10 | ASTM D2369-03 | Standard Test Method for Volatile Content of Coatings | 2003-01-10 | 구판 |
11 | ASTM D2369-98 | Standard Test Method for Volatile Content of Coatings | 2001-01-10 | 구판 |
12 | ASTM D2369-01 | Standard Test Method for Volatile Content of Coatings | 2001-01-10 | 구판 |
13 | ASTM D2369-01e1 | Standard Test Method for Volatile Content of Coatings | 2001-01-10 | 구판 |
14 | ASTM D2369-95 | Standard Test Method for Volatile Content of Coatings | 구판 | |
15 | ASTM D2369-93 | Standard Test Method for Volatile Content of Coatings | 구판 | |
16 | ASTM D2369-92 | Standard Test Method for Volatile Content of Coatings | 구판 | |
17 | ASTM D2369-90 | Standard Test Method for Volatile Content of Coatings | 구판 | |
18 | ASTM D2369-87 | Standard Test Method for Volatile Content of Coatings | 구판 | |
19 | ASTM D2369-81e1 | Standard Test Method for Volatile Content of Coatings | 구판 |
관련상품이 존재하지 않습니다.
함께 구입한 상품이 존재하지 않습니다.
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기