관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers?Tension
| 분야 | 09.01 : 고무, 자연 및 합성-일반시험 방법, 카본블랙 | ||||
|---|---|---|---|---|---|
| 적용범위 | 1.1?These test methods cover procedures used to evaluate the tensile (tension) properties of vulcanized thermoset rubbers and thermoplastic elastomers. These methods are not applicable to ebonite and similar hard, low elongation materials. The methods appear as follows:
Note 1:?These two different methods do not produce identical results. 1.2?The values stated in either SI or non-SI units shall be regarded separately as normative for this standard. The values in each system may not be exact equivalents; therefore each system must be used independently, without combining values. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
| 국제분류(ICS)코드 | 83.060 : 고무 | ||||
| 페이지수 | 14 | ||||
| Edition | 16(2021) |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASTM D412-16(2021) | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers?Tension | 2021-05-01 | 표준 |
| 2 | ASTM D412-16e1 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers?Tension | 2016-11-01 | 구판 |
| 3 | ASTM D412-16 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2016-11-01 | 구판 |
| 4 | ASTM D412-16 REDLINE | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2016-11-01 | 구판 |
| 5 | ASTM D412-15a | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2015-12-01 | 구판 |
| 6 | ASTM D412-15 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2015-10-01 | 구판 |
| 7 | ASTM D412-06a(2013) | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2013-01-01 | 구판 |
| 8 | ASTM D412-06ae2 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2006-12-15 | 구판 |
| 9 | ASTM D412-06ae1 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2006-12-15 | 구판 |
| 10 | ASTM D412-06a | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers-Tension | 2006-12-15 | 구판 |
| 11 | ASTM D412-06 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers-Tension | 2006-11-15 | 구판 |
| 12 | ASTM D412-98a(2002)e1 | Standard Test Methods for Vulcanized Rubber and Thermoplastic Elastomers—Tension | 2002-12-10 | 구판 |
| 13 | ASTM D412-98a | Standard Test Methods for Vulcanized Rubber and Thermoplastic Rubbers and Thermoplastic Elastomers-Tension | 1998-03-10 | 구판 |
| 14 | ASTM D412-68 | Standard Method Of Tension Testing Of Vulcanized Rubber | 구판 |
관련상품이 존재하지 않습니다.
ASTM D2240-15(2021) - Standard Test Method for Rubber Property?Durometer Hardness 상세보기
ASTM D573-04(2019) - Standard Test Method for Rubber—Deterioration in an Air Oven 상세보기
ASTM D430-06(2018) - Standard Test Methods for Rubber Deterioration—Dynamic Fatigue 상세보기
ASTM D624-00(2020) - Standard Test Method for Tear Strength of Conventional Vulcanized Rubber and Thermoplastic Elastomers 상세보기
ASTM D471-16a - Standard Test Method for Rubber Property—Effect of Liquids 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
