관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Standard Practice for Using Flame Photometric Detectors in Gas Chromatography
| 분야 | 03.06 : 분자의 분광학;표면분석 |
|---|---|
| 적용범위 | 1.1?This practice is intended as a guide for the use of a flame photometric detector (FPD) as the detection component of a gas chromatographic system. 1.2?This practice is directly applicable to an FPD that employs a hydrogen-air flame burner, an optical filter for selective spectral viewing of light emitted by the flame, and a photomultiplier tube for measuring the intensity of light emitted. 1.3?This practice describes the most frequent use of the FPD which is as an element-specific detector for compounds containing sulfur (S) or phosphorus (P) atoms. However, nomenclature described in this practice are also applicable to uses of the FPD other than sulfur or phosphorus specific detection. 1.4?This practice is intended to describe the operation and performance of the FPD itself independently of the chromatographic column. However, the performance of the detector is described in terms which the analyst can use to predict overall system performance when the detector is coupled to the column and other chromatographic system components. 1.5?For general gas chromatographic procedures, Practice E260 should be followed except where specific changes are recommended herein for use of an FPD. 1.6?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.7?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific safety information, see Section 4, Hazards. 1.8?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| 국제분류(ICS)코드 |
17.180.30 : 광학 측정 기구
71.040.50 : 물리화학적인 분석 방법 |
| 페이지수 | 12 |
| Edition | 95(2021)e1 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASTM E840-95(2021)e1 | Standard Practice for Using Flame Photometric Detectors in Gas Chromatography | 2021-04-01 | 표준 |
| 2 | ASTM E840-95(2013) | Standard Practice for Using Flame Photometric Detectors in Gas Chromatography | 2013-01-01 | 구판 |
| 3 | ASTM E840-95(2005) | Standard Practice for Using Flame Photometric Detectors in Gas Chromatography | 2005-09-01 | 구판 |
| 4 | ASTM E840-95 | Standard Practice for Using Flame Photometric Detectors in Gas Chromatography | 2000-01-01 | 구판 |
| 5 | ASTM E840-95(2000) | Standard Practice for Using Flame Photometric Detectors in Gas Chromatography | 2000-01-01 | 구판 |
관련상품이 존재하지 않습니다.
ASTM D7671-21 - Standard Test Method for Corrosiveness to Silver by Automotive Spark?Ignition Engine Fuel?Silver Strip Method 상세보기
ASTM D6839-21a - Standard Test Method for Hydrocarbon Types, Oxygenated Compounds, Benzene, and Toluene in Spark Ignition Engine Fuels by Multidimensional Gas Chromatography 상세보기
ASTM D6667-21 - Standard Test Method for Determination of Total Volatile Sulfur in Gaseous Hydrocarbons and Liquefied Petroleum Gases by Ultraviolet Fluorescence 상세보기
ASTM D7683-21 - Standard Test Method for Cloud Point of Petroleum Products and Liquid Fuels (Small Test Jar Method) 상세보기
ASTM D7995-19 - Standard Test Method for Total Water in Liquid Butane by Liquefied Gas Sampler and Coulometric Karl Fischer Titration 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
