관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
분야 | 11.02 : 물 (Ⅱ) |
---|---|
적용범위 | 1.1 This test method covers the determination of total and organic carbon in water and waste water, including brackish waters and brines in the range from 2 to 20 000 mg/L. This test method has the advantages of a wide range of concentration which may be determined without sample dilution and the provision for boat or capillary introduction of samples containing sediments and particulate matter where syringe injection is inappropriate. 1.2 This procedure is applicable only to that carbonaceous matter in the sample that can be introduced into the reaction zone. When syringe injection is used to introduce samples into the combustion zone, the syringe needle opening size limits the maximum size of particles that can be present in samples. Sludge and sediment samples must be homogenized prior to sampling with a micropipetor or other appropriate sampler and ladle introduction into the combustion zone is required. 1.3 The precision and bias information reported in this test method was obtained in collaborative testing that included waters of the following types: distilled, deionized, potable, natural, brine, municipal and industrial waste, and water derived from oil shale retorting. Since the precision and bias information reported may not apply to waters of all matrices, it is the user’s responsibility to ensure the validity of this test method on samples of other matrices. 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see 9.1 and 10.2.1. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
국제분류(ICS)코드 | 13.060.50 : 화학 물질에 대한 물의 시험 |
페이지수 | 8 |
Edition | 05(2020) |
No. | 표준번호 | 표준명 | 발행일 | 상태 |
---|---|---|---|---|
1 | ASTM D4129-05(2020) | Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection | 2020-01-01 | 표준 |
2 | ASTM D4129-05(2013) | Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection | 2013-05-01 | 구판 |
3 | ASTM D4129-05(2012) | Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection | 2012-01-01 | 구판 |
4 | ASTM D4129-05 | Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection | 2005-03-01 | 구판 |
5 | ASTM D4129-98(2003) | Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection | 1998-12-10 | 구판 |
6 | ASTM D4129-98 | Standard Test Method for Total and Organic Carbon in Water by High Temperature Oxidation and by Coulometric Detection | 1998-12-10 | 구판 |
관련상품이 존재하지 않습니다.
BS EN 1484:1997 - Water analysis. Guidelines for the determination of total organic carbon (TOC) and dissolved organic carbon (DOC). 상세보기
ASTM D6691-24a - Standard Test Method for Determining Aerobic Biodegradation of Plastic Materials in the Marine Environment by a Defined Microbial Consortium or Natural Sea Water Inoculum 상세보기
ASTM D4839-03(2017) - Standard Test Method for Total Carbon and Organic Carbon in Water by Ultraviolet, or Persulfate Oxidation, or Both, and Infrared Detection 상세보기
ASTM D5904-02(2017) - Standard Test Method for Total Carbon, Inorganic Carbon, and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection 상세보기
ASTM D6317-15 - Standard Test Method for Low Level Determination of Total Carbon, Inorganic Carbon and Organic Carbon in Water by Ultraviolet, Persulfate Oxidation, and Membrane Conductivity Detection 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기