관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Standard Test Methods for Linear Density of Textile Fibers
| 분야 | 07.01 : 섬유(Ⅰ) | |||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| 적용범위 | 1.1 These test methods cover the measurement of mass per unit length (linear density) of textile fibers and filaments. Direct weighing and vibroscope procedures with modifications for crimped and uncrimped fibers are included. The options and sections are listed below.
Note 1: For linear density of short lengths of yarn, refer to Test Method D1059. For cotton linear density, refer to Test Methods D1769 and D2480. For measurement of wool diameter, refer to Test Methods D1282, D2130, and D3510. 1.2 The crimp, taper, and cross-sectional shape of the fiber may influence the linear density measured by single-fiber weighing and vibroscope. 1.3 These test methods measure the linear density of fibers with moisture in equilibrium with the standard atmosphere for testing textiles. The fiber moisture under these conditions is not necessarily the same as the commercial moisture regain for the fibers. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
|||||||||||||||||||||||||||
| 국제분류(ICS)코드 | 59.060.01 : 섬유직물 일반 | |||||||||||||||||||||||||||
| 페이지수 | 10 | |||||||||||||||||||||||||||
| Edition | 07(2018) | |||||||||||||||||||||||||||
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASTM D1577-07(2018) | Standard Test Methods for Linear Density of Textile Fibers | 2018-07-01 | 표준 |
| 2 | ASTM D1577-07(2012) | Standard Test Methods for Linear Density of Textile Fibers | 2012-07-01 | 구판 |
| 3 | ASTM D1577-07 | Standard Test Methods for Linear Density of Textile Fibers | 2007-01-01 | 구판 |
| 4 | ASTM D1577-96 | Standard Test Methods for Linear Density of Textile Fibers | 2001-09-10 | 구판 |
| 5 | ASTM D1577-01 | Standard Test Methods for Linear Density of Textile Fibers | 2001-09-10 | 구판 |
관련상품이 존재하지 않습니다.
TAPPI T 452 (2018 Edition) - Brightness of pulp, paper, and paperboard (directional reflectance at 457 nm) 상세보기
TAPPI T 441 (2020 Edition) - Water absorptiveness of sized (non-bibulous) paper, paperboard, and corrugated fiberboard (Cobb test) 상세보기
TAPPI T 425 (2011 Edition, 2021) - Opacity of paper (15/d geometry, illuminant A/2°, 89% reflectance backing and paper backing) * Includes all amendments and changes through Reaffirmation Notice , 2021 상세보기
TAPPI T 411 (2015 Edition, 2021) - Thickness (caliper) of paper, paperboard, and combined board * Includes all amendments and changes through Reaffirmation Notice , 2021 상세보기
TAPPI T 410 (13th Edition, 2019) - Grammage of paper and paperboard (weight per unit area) * Includes all amendments and changes through Reaffirmation Notice , 2019 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
