ASTM B107/B107M-12 Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire

관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.

PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)

PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)

구판 판매

ASTM B107/B107M-12

Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire

- 발행일 : 2012-11-01
- 발행기관 : ASTM

언어	제공형태	판매가격	선택
영어	PDF	141,300원
영어	PRINT	141,300원

장바구니 담기

상품이 장바구니에 담겼습니다.

장바구니로 이동

상세정보

분야

02.02 : 알루미늄 및 마그네슘 합금

적용범위

1.1 This specification covers magnesium-alloy extruded bars, rods, profiles, tubes, and wire of the composition given in Table 1.

TABLE 1 Chemical Requirements^A

Note 1—Analysis shall regularly be made only for the elements specifically mentioned in this table. If, however, the presence of other elements is suspected or indicated in the course of routine analysis to be in amounts greater than the specified limits, further analysis shall be made to determine that the total of these other elements is not in excess of the limits specified in the last column of the table.

Note 2—The following applies to all specified limits in this table: For purposes of acceptance and rejection, an observed value or a calculated value obtained from analysis should be rounded-off to the nearest unit in the last right-hand place of figures used in expressing the specified limit.

Alloy^B		Composition, %
UNS No.	ASTM No.	Magnesium	Alumi- num	Cal- cium	Cop- per	Iron	Lithium	Man- ganese	Neodymium	Nickel	Rare Earths	Sili- con	Yttrium	Zirco- nium, min	Zinc	Other Impurities, each	Total Other^C Impurities
M11311	AZ31B	remainder	2.5-3.5	0.04	0.05	0.005		0.20-1.0		0.005		0.10		...	0.6-1.4		0.30
M11312	AZ31C	remainder	2.4-3.6	...	0.10	...		0.15-1.0^D		0.03		0.10		...	0.50-1.5		0.30
M11610	AZ61A	remainder	5.8-7.2	...	0.05	0.005		0.15-0.5		0.005		0.10		...	0.40-1.5		0.30
M11800	AZ80A	remainder	7.8-9.2	...	0.05	0.005		0.12-0.5		0.005		0.10		...	0.20-0.8		0.30
M15100	M1A	remainder	...	0.30	0.05	...		1.2-2.0		0.01		0.10		...	...		0.30
M18432	WE43B	remainder	...	...	0.02	0.010	0.2	0.03	2.0-2.5	0.005	1.9^E	...	3.7-4.3	0.40-1.0	^F	0.01	...
M18410	WE54A	remainder	...	...	0.03	...	0.2	0.03	1.5-2.0	0.005	2.0^E	0.01	4.75-5.5	0.40-1.0	0.20	0.2	...
M16400	ZK40A	remainder	...	...	...	...		...		...		...		0.45	3.5–4.5		0.30
M16600	ZK60A	remainder	...	...	...	...		...		...		...		0.45	4.8-6.2		0.30

^A Limits are in weight percent maximum unless shown as a range or otherwise stated.

^B These alloy designations were established in accordance with Practice B951 (see also Practice E527).

^C Includes listed elements for which no specific limit is shown.

^D Manganese minimum limit need not be met if iron is 0.005 %, or less.

^E Other Rare Earths shall be principally heavy rare earths, for example, Gadolinium, Dysprosium, Erbium, and Ytterbium. Other Rare Earths are derived from the Yttrium, typically 80 % Yttrium 20 % heavy rare earths.

^F Zinc + Silver content shall not exceed 0.20 % in WE43B.

1.2 The values stated in either inch-pound or SI units are to be regarded separately as standards. The SI units are shown in brackets or in separate tables or columns. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other. Combining values from the two systems may result in nonconformance with the specification.

1.3 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.

국제분류(ICS)코드

페이지수

Edition

이력정보

No.	표준번호	표준명	발행일	상태
1	ASTM B107/B107M-13(2021)	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2021-12-01	표준
2	ASTM B107/B107M-13	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2013-11-01	구판
3	ASTM B107/B107M-13 REDLINE	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2013-11-01	구판
4	ASTM B107/B107M-12	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2012-11-01	구판
5	ASTM B107/B107M-07	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2007-06-01	구판
6	ASTM B107/B107M-06	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2006-03-01	구판
7	ASTM B107/B107M-00	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2000-05-10	구판
8	ASTM B107/B107M-94	Standard Specification for Magnesium-Alloy Extruded Bars, Rods, Profiles, Tubes, and Wire	2000-05-10	구판

관련상품

관련상품이 존재하지 않습니다.
다른 사람이 함께 구입한 상품

함께 구입한 상품이 존재하지 않습니다.
추천 상품

IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기

IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기

KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기

KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기

KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기

해외표준

ASTM B107/B107M-12

상세정보

이력정보

관련상품

다른 사람이 함께 구입한 상품

추천 상품

전체서비스 보기