관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Vitreous and porcelain enamels — Low-voltage test for detecting and locating defects — Part 1: Swab test for non-profiled surfaces
| 분야 | ISO/TC 107 : Metallic and other inorganic coatings |
|---|---|
| 적용범위 | This document specifies two low voltage tests for detecting and locating defects that extend to the basis metal in vitreous and porcelain enamel coatings. Method A (electrical) is applicable to the rapid detection and determination of the general location of defects. Method B (optical), based on colour effects, is applicable to the more precise detection of defects and their exact locations. Both methods are commonly applied to flat surfaces. For more intricate shapes, such as undulated and/or corrugated surfaces, ISO 8289-2 is applicable. NOTE 1 Selection of the correct test method is critical to distinguish the areas of increased conductivity detected by method B from actual pores that extend to the basis metal, which can be detected by both methods. NOTE 2 The low voltage test is a non-destructive method of detecting defects and, therefore, is completely different from the high voltage test specified in ISO 2746. The results of the high and low voltage tests are not comparable and will differ. |
| 국제분류(ICS)코드 | 25.220.50 : 에나멜 |
| 페이지수 | 5 |
| Edition | 1 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ISO 8289-1:2020 | Vitreous and porcelain enamels — Low-voltage test for detecting and locating defects — Part 1: Swab test for non-profiled surfaces | 2020-02-10 | 표준 |
ISO 8289-2:2019 - Vitreous and porcelain enamels — Low-voltage test for detecting and locating defects — Part 2: Slurry test for profiled surfaces 상세보기
ISO 8289-2:2019 - Vitreous and porcelain enamels — Low-voltage test for detecting and locating defects — Part 2: Slurry test for profiled surfaces 상세보기
ISO 28706-2:2017 - Vitreous and porcelain enamels — Determination of resistance to chemical corrosion — Part 2: Determination of resistance to chemical corrosion by boiling acids, boiling neutral liquids, alkaline liquids and/or their vapours 상세보기
ISO 2178:2016 - Non-magnetic coatings on magnetic substrates — Measurement of coating thickness — Magnetic method 상세보기
ISO 5001:2012 - Cold-reduced carbon steel sheet for vitreous enamelling 상세보기
ISO 28723:2008 - Vitreous and porcelain enamels — Determination of the edge covering on enamelled steel plate to be used in heat exchangers 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
