관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Radiofrequency identification of animals — Part 7: Synchronization of ISO 11785 identification systems
| 분야 | ISO/TC 23/SC 19 : Agricultural electronics |
|---|---|
| 적용범위 | ISO 24631-7:2012 specifies rules and procedures for synchronizing RFID transceivers while reading transponders used in individual animal identification complying to ISO 11784 and ISO 11785. The synchronization scheme described herein may be fully implemented within each reader, and such readers when attached to the synchronization bus create a peer-to-peer network (all readers are equal ? there is no dedicated master). Additionally, a cluster of readers, which could be in a master/slave configuration, may also be added to the bus using a dedicated, manufacturer specific Synchronization Interface. The Synchronization Interface presents to the synchronization bus electrical characteristics identical to those of a single peer-to-peer reader. The transceiver conformance standard ISO 24631-2 permits activation on/off timing tolerances of −0/+1 ms and therefore gives reader manufacturers options as to their preferred method for detecting the HDX header; partial or full. However, when synchronizing readers, irrespective of which header detection method is used, it is critical that all readers adhere strictly to the specific timings and timing tolerances as given in the timing diagrams. Particular attention should also be given to fault diagnostics which becomes more important when a reader network comprises products from different manufacturers. The obvious case is where a reader which is part of a network has become detached e.g. sync cable break, and it considers it's self to be now standalone and thus permitted to operate asynchronously to the detriment of all other readers. |
| 국제분류(ICS)코드 | 65.040.99 : 농장 및 설비에 관련된 기타 규격 |
| 페이지수 | 17 |
| Edition | 1 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ISO 24631-7:2012 | Radiofrequency identification of animals — Part 7: Synchronization of ISO 11785 identification systems | 2012-12-03 | 표준 |
ISO/FDIS 24631-1 - Radiofrequency identification of animals — Part 1: Evaluation of conformance of RFID transponders with ISO 11784 and ISO 11785 (including granting and use of a manufacturer code) 상세보기
ISO/DIS 24631-3 - Radiofrequency identification of animals — Part 3: Evaluation of performance of RFID transponders conforming with ISO 11784 and ISO 11785 상세보기
ISO 24631-6:2011 - Radiofrequency identification of animals — Part 6: Representation of animal identification information (visual display/data transfer) 상세보기
ISO 24631-5:2014 - Radio frequency identification of animals — Part 5: Procedure for testing the capability of RFID transceivers of reading ISO 11784 and ISO 11785 transponders 상세보기
ISO 24631-1:2017 - Radiofrequency identification of animals — Part 1: Evaluation of conformance of RFID transponders with ISO 11784 and ISO 11785 (including granting and use of a manufacturer code) 상세보기
ISO 24631-6:2011 - Radiofrequency identification of animals — Part 6: Representation of animal identification information (visual display/data transfer) 상세보기
ISO 14223-1:2011 - Radiofrequency identification of animals — Advanced transponders — Part 1: Air interface 상세보기
ISO 14223-2:2010 - Radiofrequency identification of animals — Advanced transponders — Part 2: Code and command structure 상세보기
ISO 11784:1996 - Radio frequency identification of animals — Code structure 상세보기
ISO 11785:1996 - Radio frequency identification of animals — Technical concept 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
