관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
구판
판매
Geotechnical investigation and testing — Laboratory testing of soil — Part 6: Fall cone test
| 분야 | ISO/TC 182 : Geotechnics |
|---|---|
| 적용범위 | ISO/TS 17892-6:2004 specifies the laboratory determination of undrained shear strength of both undisturbed and remoulded specimen of saturated fine grained cohesive soils by use of a fall-cone. This document specifies the fall-cone test, in which a cone is allowed to fall with its tip towards a soil specimen, whereupon the penetration of the cone into the soil is measured. Tests performed according to this test yield penetration values which can be used to estimate the undrained shear strength. The test is applicable to both undisturbed and remoulded soil test specimen. For undisturbed soil test specimen, the results of the test are dependent on the quality of the specimen. Because of possible effects of anisotropy, it can also differ depending on what undrained shear strength the relation refers to. The evaluated value of the undrained shear strength of the 'undisturbed' soil refers to its state during the test in the laboratory. This value is not necessarily indicative of the undrained shear strength of the soil in its natural state in the field. Therefore, the test should be regarded as an index test. NOTE 1 For non-homogeneous soil samples, this method yields values of the undrained shear strength which are less representative for the bulk shear strength of the sample than other tests involving a larger volume of soil. NOTE 2 For disturbed soil samples and fissured soil samples this method normally yields higher strength values than tests involving a larger volume of soil. |
| 국제분류(ICS)코드 |
93.020 : 토공. 굴착. 기초건설. 갱내작업
13.080.20 : 토양의 물리적 특성 |
| 페이지수 | 8 |
| Edition | 1 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ISO 17892-6:2017 | Geotechnical investigation and testing — Laboratory testing of soil — Part 6: Fall cone test | 2017-03-03 | 표준 |
| 2 | ISO/TS 17892-6:2004 | Geotechnical investigation and testing — Laboratory testing of soil — Part 6: Fall cone test | 2004-10-21 | 구판 |
ISO 17892-1:2014 - Geotechnical investigation and testing — Laboratory testing of soil — Part 1: Determination of water content 상세보기
ISO 17892-2:2014 - Geotechnical investigation and testing — Laboratory testing of soil — Part 2: Determination of bulk density 상세보기
ISO 17892-3:2015 - Geotechnical investigation and testing — Laboratory testing of soil — Part 3: Determination of particle density 상세보기
ISO 17892-4:2016 - Geotechnical investigation and testing — Laboratory testing of soil — Part 4: Determination of particle size distribution 상세보기
ISO 17892-5:2017 - Geotechnical investigation and testing — Laboratory testing of soil — Part 5: Incremental loading oedometer test 상세보기
함께 구입한 상품이 존재하지 않습니다.
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
