관심표준 등록 : 표준업데이트 시 알림을 받을 수 있습니다.
PDF : 직접 파일 다운로드 및 인쇄 (마이페이지 확인)
PRINT : 인쇄본 우편발송, 2~3일 소요(PDF파일 미제공)
표준
판매
Standard Test Method for Fluid Loss of Clay Component of Geosynthetic Clay Liners
| 분야 | 04.13 : 토목 합성 자재 |
|---|---|
| 적용범위 | 1.1 This test method covers an index method that enables the evaluation of fluid loss properties of a clay mineral film deposited on a filter paper from a 6 % solids slurry of clay mineral at 100-psi (kPa) pressure as a measure of its usefulness for permeability or hydraulic conductivity reduction in geosynthetic clay liners (GCL). This test method is not applicable for clays with polymers. 1.2 This test method is adapted from American Petroleum Institute drilling fluid specifications for bentonite. 1.3 Powdered clay mineral is tested as produced; granular clay mineral should be ground to 100 % passing a 100 mesh U.S. Standard Sieve with a minimum of 65 % passing a 200 mesh U.S. Standard Sieve with the whole ground product used for testing. 1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.2 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
| 국제분류(ICS)코드 | 59.080.70 : 지오섬유 |
| 페이지수 | 7 |
| Edition | 19 |
| No. | 표준번호 | 표준명 | 발행일 | 상태 |
|---|---|---|---|---|
| 1 | ASTM D5891/D5891M-19 | Standard Test Method for Fluid Loss of Clay Component of Geosynthetic Clay Liners | 2019-08-01 | 표준 |
| 2 | ASTM D5891/D5891M-19 REDLINE | Standard Test Method for Fluid Loss of Clay Component of Geosynthetic Clay Liners | 2019-08-01 | 표준 |
| 3 | ASTM D5891/D5891M-02(2016)e1 | Standard Test Method for Fluid Loss of Clay Component of Geosynthetic Clay Liners | 2016-01-01 | 구판 |
관련상품이 존재하지 않습니다.
ASTM D4751-20 - Standard Test Methods for Determining Apparent Opening Size of a Geotextile 상세보기
BS EN 15382:2018 - Geosynthetic barriers. Characteristics required for use in transportation infrastructure. 상세보기
BS EN 14150:2019 - Geosynthetic barriers. Determination of permeability to liquids. 상세보기
BS EN 13257:2016 - Geotextiles and geotextile-related products. Characteristics required for use in solid waste disposals. 상세보기
BS EN 13256:2016 - Geotextiles and geotextile-related products. Characteristics required for use in the construction of tunnels and underground structures. 상세보기
IEC TS 63134:2020 - Active assisted living (AAL) use cases 상세보기
IEC 60034-5:2020 RLV - Rotating electrical machines - Part 5: Degrees of protection provided by the integral design of rotating electrical machines (IP code) - Classification 상세보기
KS B ISO TS 25740-1 - 에스컬레이터 및 무빙워크에 대한 안전요건 — 제1부: 세계공통 필수 안전요건(GESRs) 상세보기
KS B ISO TS 8100-21 - 승객 및 화물 운송용 엘리베이터 —제21부: 세계공통 필수안전요건(GESRs)을 충족하는 세계공통 안전 파라미터(GSPs) 상세보기
KS C IEC TS 62872 - 산업 시설과 스마트 그리드 사이의 산업 공정 측정, 제어 및 자동화 시스템 인터페이스 상세보기
KS표준
핸드북
